Термопластавтомат Demag Ergotech system 2000-840H/120V

CLAMPING UNIT
Clamping force: 2000 kN
Locking force: 2200 kN
Max. opening stroke: 575 mm
Min. mould height: 310 mm
Max. mould height: 660 mm (760 mm with WA)
Max. distance between platens: 1235 mm (1335 mm with WA)
Platen size (H x V): 830 x 830 mm
Distance between tie bars (H x V): 560 x 560 mm
Max. mould weight: 2500 kg
Max. mould weight on moving platen: 1700 kg
HYDRAULIC EJECTOR
Ejector stroke: 180 mm
Ejector force: 80 kN
Ejector retraction force: 35 kN
NJECTION UNIT (120)
Screw diameter: 30 mm
L/D ratio: 20
Injection pressure: 2420 bar
Stroke volume: 124 cm³
Shot weight (PS): 110 g
Max. dosing stroke: 175 mm
Max. nozzle stroke: 350 mm
Nozzle penetration depth: 40 mm (30 mm with SPI)
Nozzle contact force: 80 kN
Barrel heating power: 7.9 kW
Electric screw drive (WA): 12.6 kW
Hopper capacity: 70 l
GENERAL
Oil tank capacity: 500 l
Pump motor: 22 / 30 kW
Total installed power: 30 kW (38 kW with electric screw drive)
Dry cycles (EUROMAP 6a): 1830 / 1900 per hour
Dry cycles without nozzle retraction: 2200 / 2300 per hour
Net weight (without oil): 6200 kg
Dimensions (L x W x H): 5.1 x 1.6 x 2.1 m (length without injection unit overhang)
Noise level (idle / full load): 66 / 77 dB(A)
Demag Ergotech 150-840 NC4
INJECTION UNIT (840)
Screw diameter: 60 mm
L/D ratio: 20
Injection pressure: 1351 bar
Stroke volume: 636 cm³
Shot weight (PS): 570 g
Max. dosing stroke: 225 mm
Max. nozzle stroke: 400 mm
Nozzle penetration depth: 40 mm (30 mm with SPI)
Nozzle contact force: 80 kN
Barrel heating power: 23.1 kW
Electric screw drive (WA): 20.5 kW
Hopper capacity: 70 l
GENERAL
Oil tank capacity: 500 l
Pump motor: 22 / 30 kW
Total installed power: 45 kW (53 kW with electric screw drive)
Dry cycles (EUROMAP 6a): 1700 / 1870 per hour
Dry cycles without nozzle retraction: 2000 / 2200 per hour
Net weight (without oil): 7700 kg
Dimensions (L x W x H): 5.4 x 1.6 x 2.1 m (length without injection unit overhang)
Noise level (idle / full load): 66 / 77 dB(A)