Вентиляционное оборудование Teka AIRTECH P18

Machine type: Dust extraction,filtration TEKA
Dust extraction,filtering,welding fume extraction,self-cleaning patron filter,pneumatic,vacuum TEKA AIRTECH P18
The main
areas of application for the systems are industrial plants/welding shops where it is
where it is not possible to realize spot extraction
point extraction or where point extraction
is not sufficient to maintain clean
air on the shop floor
Side-mounted ducts with point
capture point sucks in contaminated air
air and lead it to the filter section
Here
contaminants in the form of fine
particles cover the surface of the filter
patron filter
An administered pulse of compressed air
cleans the cartridge filters
automatically
at the required intervals. After the impact of the compressed air
the particles
collected on the surface of the filters break off
off and fall into the dust tank
The cleaned air is returned to the work room through individually adjusted
long-range nozzles. At the same time
ejection of the purified air directs the contaminated air of the hall towards the
toward the extraction channels
Filter cleaned by microprocessor controller with compressed air pulses during operation
thus high efficiency of the device
Low demand for compressed air thanks to the system
"Power-Spray"
The AIRTECH unit series is certified by IFA in accordance with EN ISO 15012
1 or DIN EN ISO 21904-1/-2 and approved
for welding fume class W3 as a
permanent local extraction device
of welding fumes
Parameters
Capacity - 18 000 m3/h
motor power - 11Kw
vacuum - 2250 Pa
Filtration area - 324 m2 ( 9 filter cartridges 36m2 each)
Fan in sound-absorbing housing
Control cabinet with electrical documentation
Noise level - 72 dB
Dimensions
Base width - 1.44m x 1.44m
Width with outlet channels - 8.5m
Total weight about 2400 kg
3bmh8d3d